ACC hệ THỐNG điều KHIỂN CHÂN GA INIFINITI FX35, FX 45 2003
Bạn đang xem bản rút gọn của tài liệu. Xem và tải ngay bản đầy đủ của tài liệu tại đây (37.3 KB, 2 trang )
ACC-1
ACCELERATOR CONTROL SYSTEM
B ENGINE
CONTENTS
C
D
E
F
G
H
I
J
K
L
M
SECTION ACC
A
ACC
Revision; 2004 April 2003 FX
ACCELERATOR CONTROL SYSTEM
ACCELERATOR CONTROL SYSTEM 2
Removal and Installation 2
REMOVAL 2
INSTALLATION 2
INSPECTION AFTER INSTALLATION 2
ACC-2
ACCELERATOR CONTROL SYSTEM
Revision; 2004 April 2003 FX
ACCELERATOR CONTROL SYSTEM PFP:18005
Removal and Installation ABS005ZA
REMOVAL
1. Disconnect accelerator pedal position sensor harness connector.
2. Loosen nuts, and remove accelerator pedal assembly.
CAUTION:
● Do not disassemble the accelerator pedal assembly. Do not remove the accelerator pedal posi-
tion sensor from the accelerator pedal assembly.
● Avoid impact from dropping etc. during handling.
● Be careful to keep the accelerator pedal assembly away from water.
INSTALLATION
Install in the reverse order of removal.
INSPECTION AFTER INSTALLATION
● Check that the accelerator pedal moves smoothly within the whole operation range.
● Check that the accelerator pedal securely returns to the original position.
● For the electrical inspection of the accelerator pedal position sensor, refer to EC-1247, "DTC P2138 APP
SENSOR" .
CAUTION:
When the harness connector of the accelerator pedal position sensor is disconnected, perform
″Accelerator Pedal Released Position Learning″. Refer to EC-703, "
Accelerator Pedal Released
Position Learning" .
SBIA0332E
1. Accelerator pedal assembly
