Shop Manual & ETM BCM KIA Cerato 2010 - Power Door Locks
Bạn đang xem bản rút gọn của tài liệu. Xem và tải ngay bản đầy đủ của tài liệu tại đây (254.91 KB, 10 trang )
2010 > G 1.6 DOHC > Body Electrical System
Component Location
1. ICM relay box (Door lock/unlock relay)
2. Body control module (BCM)
3. Front door lock actuator & switch
4. Rear door lock actuator & switch
6. Door lock knob
7. Door lock switch
8. Passenger compartment junction box
(Trunk lid relay)
Language
5. Trunk lid actuator & switch
2010 > G 1.6 DOHC > Body Electrical System
Inspection
Front Door Lock Actuator
1. Remove the front door trim.
(Refer to the Body group - Front door)
2. Remove the front door module.
(Refer to the Body group - Front door).
3. Disconnect the connectors from the actuator.
[LHD]
[RHD]
Language
4. Check actuator operation by connecting power and ground according to the table. To prevent damage to
the actuator, apply battery voltage only momentarily.
Rear Door Lock Actuator
1. Remove the rear door trim.
(Refer to the Body group - Rear door)
2. Remove the rear door module.
(Refer to the Body group - Rear door)
3. Disconnect the connectors from the actuator.
[LHD]
[RHD]
4. Check actuator operation by connecting power and ground according to the table. To prevent damage to
the actuator, apply battery voltage only momentarily.
Trunk lid Lock Actuator Inspection
1. Remove the trunk trim. (Refer to the Body group - trunk)
2. Disconnect the 3P connector from the actuator.
3. Check actuator operation by connecting power and ground according to the table. To prevent damage to
the actuator, apply battery voltage only momentarily.
Front Door Lock Switch
1. Remove the front door trim.
(Refer to the Body group - Front door)
2. Remove the front door module.
(Refer to the Body group - Front door).
3. Disconnect the connectors from the actuator.
[LHD]
